Knowledgebase
Knowledgebase:
Manually Setup Uktv2c Web Connect on Win 10
Posted by Graham Swift, Last modified by Graham Swift on 17 December 2015 03:11 PM

 

Manually Setup Uktv2c Web Connect on Win 10

 

Important: 

Before you change your DNS settings to use Uktv2c Web Connect, be sure to write down the current server addresses or settings on a piece of paper. It is very important that you keep these numbers for backup purposes, in case you need to revert to them at any time.

We also recommend that you print this page, in the event that you encounter a problem and need to refer to these instructions.



Manual setup

  1. From the main desktop screen, click the START button then click SettingsStep1
  2. Click on Network and Internet Step2
  3. Click on WiFi or Ethernet (depending on your type of connection but on this guide we are on an Ethernet connection) then click Change adapter settingsStep3
  4. Right Click on your network adapter and click on PropertiesStep4
  5. Uncheck the Internet Protocol Version 6 (TCP/IPv6) Step5
  6. Click on Internet Protocol Version 4 (TCP/IPv4)to highlight and click on Properties
  7. In the General tab click on Use the following DNS server addresses.
  8. Fill DNS server fields with values from the table below and click OK.
  9. Primary: 109.123.81.126
    Secondary: 204.12.213.82
  10. Click on Close buttonStep7
Important
  1. Restart the device you are planning to use with the service.

 

(3 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: